Publication no. C-2003-1110-01R |  VIEW ARTICLE

Plasticizers for Zein: Their Effect on Tensile Properties and Water Absorption of Zein Films.

J. W. Lawton (1). (1) Plant Polymer Research Unit, National Center for Agricultural Utilization Research, U. S. Department of Agriculture, Agricultural Research Service, 1815 N. University St., Peoria, IL 61604. Phone: 309-681-6419. Fax: 309-681-6691. E-mail: <lawtonjw@ncaur.usda.gov> Names are necessary to report factually on available data; however, the USDA neither guarantees nor warrants the standard of the product, and the use of the name by the USDA implies no approval of the product to the exclusion of others that may also be suitable. Cereal Chem. 81(1):1-5. Accepted August 4, 2003. This article is in the public domain and not copyrightable. It may be freely reprinted with customary crediting of the source. American Association of Cereal Chemists, Inc., 2004.

Cast zein films are brittle at room conditions, so plasticizers are added to make them more flexible. The tensile properties of these films are known to be affected by the relative humidity (RH) of the ambient air. However, little is known about how the plasticizers are affected by RH. Cast zein films were plasticized with either glycerol (GLY), triethylene glycol (TEG), dibutyl tartrate (DBT), levulinic acid (LA), polyethylene glycol 300 (PEG), or oleic acid (OA). Mechanical properties and moisture content (MC) of the films were measured after one week of storage at 3, 20, 50, 70, 81, and 93% RH. The relative humidity of the films’ storage had a great effect on the films’ tensile properties. All the films’ tensile strength and Young’s modulus values decreased as RH increased. Films containing DBT, TEG, LA, or PEG showed an increase in the percent elongation with increasing RH. Films containing GLY, OA, or no plasticizer did not show any increase in percent elongation as RH increased. The changes seen in tensile properties with increasing RH are because of zein’s hygroscopic nature. The absorbed water will further plasticize the zein. The type of plasticizer used determined the extent of the changes seen in the tensile properties of films stored at different RH values. Depending on the plasticizers used in the film, there were large differences in the amount of water absorbed. Films increasingly absorbed water depending on the plasticizer they contained in the order GLY > TEG > LA > PEG > NONE > DBT > OA. Films containing hygroscopic plasticizers like TEG absorbed too much water at high RH and became weak, but they absorbed enough water at lower RH values to not be brittle. While films containing the more hydrophobic plasticizer DBT were brittle at intermediate RH values, they had good mechanical properties at high RH values.