doi:10.1094/CCHEM-84-3-0294 |  VIEW ARTICLE

Influence of Physical Grain Characteristics on Optimal Rotor Speed During Impact Dehulling of Oats.

Douglas C. Doehlert (1,2) and Dennis P. Wiessenborn (3). (1) USDA-ARS Wheat Quality Laboratory, Harris Hall, North Dakota State University, Fargo ND 58105. (2) Corresponding author. Phone: 701-231-8069. Fax: 701-239-1377. E-mail: <douglas.doehlert@ndsu.edu> (3) Agricultural and Biosystems Engineering Department, North Dakota State University, Fargo, ND, 58105. Cereal Chem. 84(3):294-300. Accepted December 22, 2007. Copyright 2007 AACC International, Inc.

Central to commercial oat (Avena sativa L.) processing is impact dehulling. During impact dehulling, oats are fed into a spinning rotor that expels the grains against an impact ring. The impact frees the groat from the hulls. To optimize dehulling protocols, we examined the effects of physical grain characteristics and rotor speed on oat dehulling using an impact dehuller. We separated grain of three cultivars (Gem, CDC Dancer, Ronald) according to size by sieve fractionation (separation by width), disk fractionation (separation by length), and by gravity table (separation by density). Grains were characterized by mass, digital image analysis, and bulk density. Samples (50 g) were adjusted to 9% moisture and dehulled at four different rotor speeds. Groat percentage, dehulling efficiency, and groat breakage were measured after dehulling. In general, oats with higher bulk density dehulled more efficiently at slower rotor speeds, regardless of grain mass. Groat breakage increased with rotor speed and with grain mass. Adjusting dehulling conditions according to grain size improved groat yields over optimal dehulling conditions for unfractionated grains for some cultivars. More refined fractionation of grain according to bulk density may provide further improvement of groat yield during impact dehulling.